How To Fill; How To Use - HoMedics MyChill Instruction Manual

HOW TO FILL:

Caution: Before filling the unit with water, unplug the Power Adapter from the wall and from the unit.
Note: Always use two hands to carry the unit.
Personal Space Cooler Location
Place the Personal Space Cooler in the desired location prior to filling with water. The front of the unit should be located within 4 FT / 1.2
M of the desired personal cooling zone. We recommend placing a waterproof pad under the unit.
1. Be sure the cooling
cartridge is positioned with
the "V-shaped" vents facing
upward. Never operate the
unit without the cooling
cartridge.
5. Place the tank into the
MyChill cavity, making sure
the tank is firmly seated.
Water will begin to transfer
into the water reservoir.

HOW TO USE:

Plug the power adapter into the back of the unit and the other end
into a household electrical outlet.
Speed Adjustment
1. Power button to control the on/off function. Press once. Fan
motor to start at LOW speed, with LED lit.
2. Press button once to adjust the fan speed to LOW, press twice
for HIGH speed, pressing again to repeat the function.
Low Water Indicator
This unit is equipped with a low water Refill Indicator. It will flash
Red indicating the water tank needs to be refilled. The pump will
automatically turn off while the fan continues to run. At this time,
please turn the unit off and unplug it to refill the tank. Once a full
tank is placed in the unit and the unit is turned back on, the low
water indicator is reset and the pump is turned on.
2. Remove the water tank
and turn the tank upside
down – remove the tank
cap by turning it counter-
clockwise.
6. Once the water stops
emptying into the water
reservoir, remove the water
tank and refill following steps
2-5 to fully fill the water tank
and reservoir.
5
3. Fill the water tank with
clean, cool (not cold) water.
We recommend using distilled
water if you live in a hard
water area. Never use any
additive or place essential
oils into the water. Even a
few drops will damage the
unit.
7. Adjust the front vents up
or down to direct the airflow
as desired.
LED indicators
Power button
Refill indicator
The Personal Space Cooler is equipped with a safety device that
automatically shuts the unit off when the Top Cover is removed
from the water reservoir.
GB
I
4. Replace the tank cap
by turning clockwise until
tight. Do not overtighten.
8. Your personal space
cooler is ready for use.
Fan speed/
reset button