HoMedics Mychill Personal Space Cooler 2.0 Quick Start Manual

QUICK-START GUIDE
READ AND SAVE THESE INSTRUCTIONS
CAUTION: Before filling the unit with water, unplug
the power adapter from the wall and from the unit.
NOTE: Always use 2 hands to carry the unit.
PERSONAL SPACE COOLER LOCATION
Place the Personal Space Cooler in the desired
location prior to filling with water. The front of
the unit should be located within 4 FT / 1.2 M of
the desired personal cooling zone. We recommend
placing a waterproof pad under the unit.
1. Remove the water tank.
3. Fill the water tank with
clean, cool (not cold) water.
We recommend using
distilled water if you live in
a hard-water area. Never
use any additives or place
essential oils in the water.
Even a few drops will
damage the unit.
5. Place the tank into the MyChill
cavity, making sure the tank is
firmly seated. Water will begin to
transfer into the water reservoir.
7. Adjust the front vents up or
down to direct the airflow as
desired. Your Personal Space
Cooler is ready for use.
©2017 HoMedics, LLC. All Rights Reserved. HoMedics is a registered trademark of HoMedics, LLC.
MyChill and HoMedics Leaders in Home Environment are trademarks of HoMedics, LLC.
HoMedics, LLC
3000 Pontiac Trail
Commerce Township, MI 48390
2. Turn the water tank upside
down – remove the tank cap by
turning it counter-clockwise.
4. Replace the tank cap by
turning it clockwise until
tight. Do not overtighten.
6. Once the water stops emptying
into the water reservoir, remove the
water tank and refill following steps
2-5 to fully fill the water tank and
reservoir.
POWER
Plug the power adapter
into the back of the unit
and the other end into
a household electrical
outlet. Press the POWER
button to turn the unit
ON. Press the FAN
button to select speed.
QS-PAC25A
Made in China