Rear - Watchguard Firebox T35 Hardware Manual

WatchGuard Firebox T35 and T35-W Hardware Guide
Attn
The Attn indicator is yellow when you start the device with the Reset button pressed. For more
information, see
Power ( )
The Power indicator is lit to indicate power status. It is green when the Firebox is powered on.

Rear

Rear view of the Firebox:
Serial Port (Console)
The leftmost port is an RJ45 serial console port. An RJ45 serial cable is not included with the device.
USB Interfaces
The device includes two USB interfaces. Connect a USB storage device for USB backup and
restore, or to store a support snapshot. For more information, see
Network Interfaces
The Ethernet interfaces have standard RJ45 connectors and support link speeds of 10, 100, or 1000
Mbps.
The Firebox T35/T35-W has five network interfaces. These interfaces are labeled 0/WAN, 1/LAN, 2,
3, 4-PoE. Interface 4 is a PoE+ (Power over Ethernet) interface, compliant with the IEEE 802.3at
standard.
Reset Button
This resets the device. To restore the device to factory default settings, see
Settings .
Power Switch
Controls the power supplied to the device. Move the switch to position 1 to power on the device, or
position 0 to power it off.
Power Input
An AC power adapter is included with your device. Connect the AC adapter to the device and to a
power source. The power supply tip is plus (+) polarity. Use only the supplied AC power adapter.
4
Restore Factory Default Settings .
Explore Fireware
WatchGuard Technologies, Inc.
Help.
Restore Factory Default