Sanding/Finishing - Grizzly G0842 Owner's Manual

Mounting Workpiece on backing
block
items Needed
piece of Scrap Wood......................................... 1
precision ruler .................................................. 1
drill Bit ⁄ " .......................................................... 1
1
4
glue ................................................... as needed
Clamp ................................................................ 1
To mount workpiece on backing block:
1. Make backing block from a suitable size
piece of scrap wood.
important: Faces of backing block must be
flat and parallel to each other, or uneven
surfaces will cause workpiece to spin eccen-
trically, causing unnecessary vibration and
runout. It is best to mount backing block to
faceplate and turn other surface flat prior to
mounting.
2. locate and mark center of workpiece and
backing block.
3. drill a ⁄ " hole through center of backing block.
1
4
4. look through hole in backing block to line up
center with workpiece and glue and clamp
backing block to workpiece.
Note: Allow glue to cure according to manu-
facturer's instructions.
5. Steps
Follow
Workpiece on faceplate (see Page 36) to
attach backing block to faceplate.
Model G0842 (Mfd. Since 04/18)
Qty
1–3 Mounting
under

Sanding/finishing

after the turning operations are complete, the
workpiece can be sanded and finished before
removing it from the lathe, as shown in figure 50.
figure 50. typical sanding operation.
Note: Whenever sanding or finishing, move the
tool rest holder out of the way to increase per-
sonal safety and gain adequate working room.
Sandpaper Wrapping
per completely around
workpiece
your hands into mov-
ing workpiece and may
cause
Never
per or finishing materi-
Workpiece
als completely around
workpiece.
sandpa-
could pull
serious injury.
wrap sandpa-
-37-