If A Subject Cannot Be Recognized Or Captured - Sony EVI-D30 Operating Instructions Manual

If a subject cannot be
recognized or captured
Depending on the characteristic or condition of a
subject, the camera might hardly recognize the
subject. If the AT function still does not work after
the procedures mentioned in pages 14 and 15 are
repeated, select an ENTRY mode that is matched to
conditions under which the camera is used.
Normally, select the ENTRY 1.
Problem
A subject cannot be recognized
because its color is too thin.
The camera repeats mistakenly
recognizing a near object whose
color is almost identical to that of a
subject. (The frame moves from the
subject to an object whose color is
almost identical to that of the
subject.)
The camera repeats mistakenly
recognizing the backdrop such as
the wall or ceiling. (The frame
moves from the subject to the
backdrop.)
The camera does not capture a
subject correctly when the
brightness of the subject changes as
the position of the subject changes.
1
ENTRY
mode to
be selected
ENTRY 2
ENTRY 2
ENTRY 4
ENTRY 3
2
4
3
1
Press the AT ON/OFF button to enter
into the AT setting mode.
The frame and setting value appear. If the
setting value does not appear, press the DATA
SCREEN button to have the value displayed.
AT MODE P-T DRIVE
SETTING
CHASE 1
2
Repeat pressing the ENTRY button to
select a desired ENTRY mode.
Each time that button is pressed, the mode is
cyclically changed as follows:
ENTRY 1 ENTRY 2
AT MODE P-T DRIVE
SETTING
CHASE 1
3
Have the camera memorize a subject by
pressing the arrow button to move the
subject into the frame.
The position to which you place the subject
varies depending on an ENTRY mode you
select.
ENTRY 2: Place the subject so that the
portion uniform to a certain extent in color
and brightness is in the frame.
ENTRY 3: Place the subject so that it hangs
over the frame slightly.
ENTRY 4: Place the subject so that it
becomes largest within the frame, its
backdrop being out of the frame.
ENTRY1
32
Frame
ENTRY 3
ENTRY 4
ENTRY4
52
continue to next page
EN
17