Control Assembly; Control Cable Routings; C Ontrol C A B Le - Chevrolet CHEVY VAN G10 SERIES Service Manual

DEFROST
AIR
CABLE
TEMP
CABLE
Fig. 8 —Control Assembly

CONTROL ASSEMBLY

Replacement (Fig. 8)
1. D isconnect the b attery ground cable.
2. D isconnect the blow er sw itch w iring harness connector at
the low er side o f th e control.
3. Rem ove the tw o control to instru m en t panel m ounting
screws and carefully low er the con tro l far enough to gain
access to the bow den cable attachm ents.
DEFROSTER
CABLE
W ITHOUT RAD IO
C A U T IO N :
ing the bowden cables while lowering the control.
4. D isconnect the three bow den cables, the control illum i­
natio n bulb, and remove the control from the vehicle.
5. Remove th e blow er sw itch screws and rem ove th e blow er
sw itch.
6. T o install, reverse Steps 1-5 above.
N O T E :
reinstalling the control
screw.
CONTROL CABLES
Replacement (Fig. 9)
1. D isconnect the b attery ground cable.
2. U nsnap th e engine cover fro n t latches. Remove the tw o
cover to floorpan screws and remove the cover.
3. Remove th e left d istrib u to r d u ct attaching screw and
remove the duct.
4.
Defroster Cable
to dash panel (2) screws.
5. Pry o ff the cable eyelet clip at b o th the door and control
lever. Rem ove the cable attaching screw at b o th door and
co n tro l locations.
6. A tta ch a 4 ' piece o f wire to the door end o f the cable.
Place protective tape around the cable m ounting tab and
attach ed wire an d carefully pull the cable from the
vehicle. Rem ove th e tape and disconnect the 4 ' piece o f
wire.
N O T E :
on the radio speaker bracket to get clearance for
cable removal.
VIEW A
Fig. 9 -C o n tr o l Cable Routings
Care should be taken to prevent kink­
Be sure to reinstall all ground wires when
to I.P. lower
O n ly -R em o v e the radio speaker bracket
On defroster cables, pull rearward slightly
WITH RAD IO
HEATER 1A-5
mounting
C H E V Y V A N SH O P M A N U A L