Important Safety Warnings; Ups Location Warnings; Equipment Connection Warnings; Battery Warnings - Tripp Lite SmartOnline SVTX Series Owner's Manual

2. Important Safety Warnings

SAVE THESE INSTRUCTIONS
This manual contains important instructions and warnings that should be followed during the installation and maintenance
of all Tripp Lite SmartOnline SVT 3-Phase 10kVA, 20kVA and 30kVA UPS Systems and their batteries. Failure to heed these
warnings may affect your warranty.

2.1 UPS Location Warnings

• Install the UPS indoors, away from heat, direct sunlight, dust, and excess moisture or other conductive contaminants.
• Install the UPS in a structurally sound area. The UPS is extremely heavy; take care when moving and lifting the unit.
• Only operate the UPS at indoor temperatures between 0° C and 40° C.
• Optimum UPS performance and maximum battery life is met when the operating temperature is maintained between 17° C and 25° C.
• Ensure the installation area has sufficient space for maintenance and ventilation of the UPS system. Maintain a minimum clearance of
50 cm from the rear, front and both sides of the UPS for maintenance and ventilation.
• Do not install the UPS near magnetic storage media, as this may result in data corruption.

2.2 Equipment Connection Warnings

• Use of this equipment in life support applications where failure of this equipment can reasonably be expected to cause the failure of
the life support equipment or to significantly affect its safety or effectiveness is not recommended. Do not use this equipment in the
presence of a flammable anesthetic mixture with air, oxygen or nitrous oxide.
• The UPS system contains its own energy source (battery). The output terminals may be live even when the UPS is not connected to an
AC supply.

2.3 Battery Warnings

• The UPS does not require routine maintenance. Do not open the UPS for any reason. There are no user-serviceable parts inside.
• Batteries can present a risk of electrical shock and burn from high short-circuit current. Observe proper precautions. Do not dispose of
the batteries in a fire. Do not open the UPS or batteries. Do not short or bridge the battery terminals with any object. Disconnect and
turn off the UPS before performing battery replacement. Use tools with insulated handles. Battery replacement should be performed
only by authorized service personnel using the same number and type of batteries (Sealed Lead-Acid). The batteries are recyclable.
Refer to your local codes for disposal requirements or visit http://www.tripplite.com/support/recycling-program for recycling information.
Tripp Lite offers a complete line of UPS System Replacement Battery Cartridges (R.B.C.).Visit Tripp Lite on the Web at
http://www.tripplite.com/products/battery-finder/ to locate the specific replacement battery for your UPS.
• Connect only Tripp Lite battery modules to your UPS system's external battery hardware terminals.
• Do not operate the UPS without batteries.
• Fuses should be replaced only by factory authorized personnel. Blown fuses should be replaced only with fuses of the same number
and type.
• Potentially lethal voltages exist within this unit as long as the battery supply is connected. Service and repair should be done only by
trained personnel. During any service work, the UPS should be turned off or put into manual bypass and fuses should be removed from
all connected battery modules.
• Do not connect or disconnect the battery modules while the UPS is operating from the battery supply.
WARNING: In order to avoid any hazardous conditions during UPS installation and maintenance, these tasks may
be performed only by qualified and experienced electricians.
4