Sony Handycam DCR-SR90E Operating Manual page 95

On the LCD screen
• Do not exert excessive pressure on the LCD
screen. Blurs appear and it may cause a
malfunction of your camcorder.
• If your camcorder is used in a cold place, a
residual image may appear on the LCD screen.
This is not a malfunction.
• While you are using your camcorder, the back of
the LCD screen may heat up. This is not a
malfunction.
To clean the LCD screen
x
If fingerprints or dust make the LCD screen
dirty, use the cleaning cloth (optional) to
clean the LCD screen.
When you use the LCD Cleaning Kit
(optional), do not apply the cleaning liquid
directly to the LCD screen. Use cleaning
paper moistened with the liquid.
On adjustment of the LCD screen
x
(CALIBRATION)
The buttons on the touch panel may not work
correctly. If this happens, follow the
procedure below. It is recommended you
connect your camcorder to the wall socket
using the supplied AC Adaptor during the
operation.
1 Slide the POWER switch to light up the
(PLAY/EDIT) lamp.
2 Remove cables other than that of the AC
Adaptor from your camcorder.
3 Touch t [SETUP] t
STANDARD SET t [CALIBRATION].
CALIBRATION
Touch the "x"
CANCEL
4 Touch the "×" displayed on the screen with
a thin object such as a corner of "Memory
Stick Duo".
The position of the "×" changes.
Touch [CANCEL] to cancel.
If you did not press the right spot, try the
calibration again.
• Do not use a sharp-pointed tool to calibrate the
• You cannot calibrate the LCD screen if you have
On handling the casing
• If the casing is soiled, clean the camcorder body
• Avoid the followings to prevent damage to the
Care and storage of the camera lens
• Wipe the surface of the lens clean with a soft cloth
• Store the lens in a well-ventilated location subject
• To prevent mold, periodically clean the lens as
To charge the pre-installed
rechargeable battery
Your camcorder has a pre-installed
rechargeable battery to retain the date, time,
1/3
and other settings even when the POWER
switch is set to OFF (CHG). The pre-installed
rechargeable battery is always charged while
you are using your camcorder but it will get
discharged gradually if you do not use your
camcorder. The rechargeable battery will be
fully discharged in about 3 months if you
do not use your camcorder at all. However,
even if the pre-installed rechargeable battery
is not charged, the camcorder operation will
not be affected as long as you are not
recording the date.
LCD screen. Doing so may damage the surface
of the screen.
rotated it, or if you have set it with the LCD screen
side facing out.
with a soft cloth lightly moistened with water, and
then wipe the casing with a dry soft cloth.
finish.
– Using chemicals such as thinner, benzin,
alcohol, chemical cloths, repellent and
insecticide and sunscreen.
– Handling with above substances on your hands.
– Leaving the casing in contact with rubber or
vinyl objects for a long period of time.
in the following instances:
– when there are fingerprints on the lens surface.
– in hot or humid locations
– when the lens is exposed to salty air such as at
the seaside.
to little dirt or dust.
described above. It is recommended that you
operate your camcorder about once a month to
keep it in optimum state for a long time.
95
Continued ,