Janome Sewist 725s Instruction Book page 30

c
r
v
t
y
b
n
u
i
o
!2
!1
!0
c Pull the buttonhole lever down as far as it will
go.
r Buttonhole lever
v Raise the foot and pass the needle thread
through the opening in the foot. Draw both
needle and bobbin threads to the left.
Insert the fabric under the foot and lower the
needle into the fabric at the starting point.
Lower the foot.
t Needle thread
y Bobbin thread
u Opening
i Starting point
NOTE:
Make sure there is no gap between the slider
and front stopper. If there is a gap, the length
of the right and left rows of the buttonhole will
differ.
o Slider
!0 Front stopper
!1 Difference
!2 There should be no gap.
b Sew slowly and stop the machine when a
buttonhole is completed.
The machine sews the front bartack and left
row first, then the back bartack and right row.
n Raise the foot and remove the fabric.
Cut both needle and bobbin threads leaving
about 4˝ (10 cm) thread ends.
Draw the needle thread to wrong side of
fabric by pulling the bobbin thread.
Then, knot the threads.
Insert a pin inside the bartack. Then cut the
opening with seam ripper.
Take care not to cut the stitches.
26