Optimizing The System - Sennheiser freePORT Instructions For Use Manual

freeport.book Seite 23 Mittwoch, 18. Mai 2005 8:35 08
»
Switching the radio microphone on/off
Use the ON/OFF switch
If the radio microphone is switched on, the red LED
Note:
Remove the battery when the transmitter will not be used for
extended periods of time.
Selecting and changing a channel
Switch off the radio microphone.
Open the radio microphone (see "Inserting/replacing the battery"
on page 22).
Use a small screwdriver to set the channel selector switch
desired channel. You can switch between four different channels
(see "Selecting a channel" on page 24).
Close and lock the radio microphone.
Switch on the radio microphone again.
Sensitivity of the radio microphone
You can vary the bass reproduction by increasing/decreasing the
talking distance.

Optimizing the system

Before starting transmission, do a soundcheck and optimize the system
as follows:
Optimizing the reception
The receiver's four LEDs (RF LEVEL)
RF signal. With the transmitter, walk up and down the transmission
area and check if the received RF signal is sufficient everywhere.
Reception is good if all four LEDs light up. Please observe the following:
Transmission range depends to a large extent on location and can be
up to 100 m. Observe a minimum distance of 3 m between
transmitter and receiver. There should be a "free line of sight"
between transmitting and receiving antennas.
Do not operate the system close to metal objects such as cross
members or reinforced-concrete walls. Computers or mobile phones
in direct proximity to the antenna will interfere with the reception.
Each transmitter requires a receiver. When using several trans-
mission links simultaneously, make sure that all transmission links
operate on different channels.
¶
to switch the radio microphone on or off.
»
indicate the level of the received
²
lights up.
º
to the
23