Sony CCD-TRV108 Operating Instructions (primary manual) Operating Instructions Manual page 75

Types of trouble and their solutions
Symptom
The end search function does not
work.
The battery pack discharges quickly.
The remaining battery time indicator
does not indicate the correct time.
The power goes off although the
remaining battery time indicator
indicates that the battery pack has
enough power to operate.
The cassette cannot be removed from
the holder.
The % and Z indicators flash and no
functions except for cassette ejection
work.
The remaining tape indicator is not
displayed.
Others
Symptom
Easy Dubbing does not function.
Cause and/or Corrective Actions
• The tape was ejected after recording.
• You have not recorded on the cassette yet.
• The operating temperature is too low.
• The battery pack is not fully charged.
c Charge the battery pack fully again. (p. 11, 12)
• The battery pack is completely dead, and cannot be
recharged.
c Replace with a new battery pack. (p. 11)
• You have used the battery pack in an extremely hot or
cold environment for a long time.
• The battery pack is completely dead, and cannot be
recharged.
c Replace with a new battery pack. (p. 11)
• The battery pack is not fully charged.
• A deviation has occured in the remaining battery time.
c Charge the battery pack fully again. (p. 11, 12)
• A deviation has occured in the remaining battery time.
c Charge the battery pack fully again so that the
indication on the battery remaining indicator is correct.
(p. 11, 12)
• The power source is disconnected.
c Connect it firmly. (p. 11, 15)
• The battery pack is dead.
c Use a charged battery pack. (p. 11, 12)
• Moisture condensation has occurred.
c Remove the cassette and leave your camcorder for at
least 1 hour to acclimate. (p. 84)
• The q REMAIN is set to AUTO in the menu settings.
c Set it to ON to always display the remaining tape
indicator. (p. 70)
Cause and/or Corrective Actions
• Your VCR and/or video camera recorder is not set
correctly.
c Make sure the input selector of the VCR is set to LINE.
Also, make sure the power switch of the video camera is
set to VTR/VCR. (p. 51)
• The IR SETUP code or PAUSE MODE is not set correctly.
c Select the correct IR SETUP code and PAUSE MODE,
according to your VCR. Then confirm VCR operation
with the IR TEST function. (p. 52 to 55)
(continued on the following page)
75