Flush-Fit Installation - Miele KM 7678 FR Operating And Installation

Flush-fit installation

Flush-fit installation is only possible in
natural stone (granite, marble), solid
wood and tiled worktops. Certain
models are suitable for building into
glass worktops - please see relevant
label on the hob. When using a work-
top made from any other material,
please check first with the worktop
manufacturer that it is suitable for in-
stalling a flush fit hob.
The internal width of the base unit un-
derneath the appliance must be at
least as wide as the inner worktop cut-
out (see "Building-in dimensions -
flush fit"), so that the hob is easily ac-
cessible from underneath after install-
ation and the bottom half of the casing
can be removed for maintenance. If
the underside of the hob is not freely
accessible after installation, any seal-
ant used to plug the gaps around the
appliance must be removed to enable
the hob to be lifted out of the cut-out
should this be necessary.
Installation notes
Natural stone worktops
The hob is set directly in the cut-out.
Solid wood worktops, tiled worktops,
glass worktops
The hob is set on a wooden frame in-
side the cut-out. The frame must be
provided on site, and is not supplied
with the appliance.
Sealing strip
Dismantling the hob for service pur-
poses may damage the sealing strip
underneath the edge of the hob.
Always replace the sealing strip be-
fore reinstalling the hob.
57