Switching The Function On The Amplifier/Receiver Automatically (Amp Link); Changing The Name Of The Remote (Component) - Sony RM-TP1 Operating Instructions / Mode d’emploi Operating Instructions Manual

Switching the function on
the amplifier/receiver
automatically (AMP LINK)
You can set the commander to switch the
function on the amplifier/receiver to the
component selected in the RM SELECT screen
automatically.
The following procedure uses an example to
switch the function on the amplifier/receiver to
CD when "CD" is selected in the RM SELECT
screen.
1
Touch RM SELECT.
The RM SELECT screen appears.
2
Turn the jog dial to select the remote
(component) you want to use with the
AMP LINK function ("CD" for example).
When you touch the remote (component),
touch B to display the RM SELECT screen.
3
Touch
The pull-down menu appears.
4
Touch AMP LINK in the pull-down
menu.
The AMP LINK screen appears.
GB
28
.
5
Select the function you want to switch
the function to ("CD" for example).
A check ( ) appears in front of the selected
function.
6
Touch EXIT.
The RM SELECT screen reappears.
A appears in the box of the remote
(component) selected in step 2.
To cancel AMP LINK
Select "OFF" in the AMP LINK screen.
Changing the name of the
remote (component)
You can change the name of the remote
(component) that appears in the RM SELECT
screen (up to 10 characters).
1
Touch RM SELECT.
The RM SELECT screen appears.