Issue #5: My Water Optimizer's Hot Mode Isn't Hot; Issue #6: My Water Optimizer's Cold Mode Isn't Cold; Issue #7: My Water Optimizer Is Beeping Or Lights Are Flashing - Kenmore KM5K Use & Care Manual

Issue #5: My Water Optimizer's Hot Mode isn't hot.

Please note, this appliance is heating system is preset to a temperature range of
172.4°F - 194°F (78°C -90°C). This temperature is not adjustable.
T
Solution 1: Flip
appliance.

Issue #6: My Water Optimizer's Cold Mode isn't cold.

Please note, this appliance is cooling system is preset to a temperature range of
39.2°F - 42.8°F (4°C - 6°C). This temperature is not adjustable.
S
Solution 1: Flip
appliance.
N
Solution 2: Cold Water Tank
above average use, and requires sufficient time to replenish.
Solution 3: Compressor may have failed or lost the R-134A refrigerant. If compressor
is running continuously and/or feels extremely hot to touch, power off
Cold Mode Power
drinkpod.com.

Issue #7: My Water Optimizer is beeping or lights are flashing.

When your Water Optimizer's beeping and/or the status lights are blinking
(sometimes all 3 or just one red light), it means that the
detected water and shut down the system as a pre-caution against flooding. This is why
we recommend laying a towel down over the sensor when setting up the unit or changing
filters, so as not to get water onto the interior base.
To clear/reset: Unplug the
Stainless Steel Cabinet Door
red stripe) running down to the base, on left side behind the filters, to the
Leak Detection
Leak Detection Sensor
the entire cavity. Re-plug the unit to power to reset the program. Check for any leaking
water. Reinstall the
Hot Mode Power Switch
Cold Mode Power Switch
water level may have been drained and exhausted by
Switch, and contact support at 1-844-374-6576, or
U
110v Power
to filter area to inside. Trace the white wire (with
Sensor. Remove the screw on the mounting bracket. Lift out the
(looks like a circuit board). Dry it thoroughly, and then dry out
Leak Detection
up to "ON" / "I" position at rear of the
up to "ON" / "I" position at rear of the
Cord. Open the
Sensor, mounting bracket, and screw. Good to go!
Troubleshooting Your Water Optimizer 17
S
Leak Detection Sensor
M
support@
has
R