Rcv_Rst Instruction - Siemens SIMATIC S7 System Manual

STATUS
(W#16#...)
80E4
0094
0095
0096
0097
0098
0099
8.7.7

RCV_RST instruction

Parameter
REQ
PORT
DONE
ERROR
STATUS
S7-1200 Programmable controller
System Manual, 11/2009, A5E02486680-02
Description
Message terminated because calculated length exceeds buffer size
Message terminated due to received maximum character length
Message terminated because of message timeout
Message terminated because of inter-character timeout
Message terminated because of response timeout
Message terminated because the "N+LEN+M" length condition was satisfied
Message terminated because of end sequence was satisfied
RCV_RST (Receiver Reset) clears the receive buffers in the
CM.
Parameter Data type Description
type
IN Bool
IN PORT
OUT Bool
OUT Bool
OUT Word
Point-to-Point (PtP) communications
Activates the receiver reset on the rising edge of this enable
input
Communication port identifier:
The port must be specified using the module's logical
address.
When TRUE for one scan, indicates that the last request was
completed without errors.
When TRUE, shows that the last request was completed with
errors. Also, when this output is TRUE, the STATUS output
will contain related error codes.
Error code
8.7 Point-to-Point instructions
263