Honeywell TCPA1BS Installation Instructions Manual page 2

Wireless Panic Button
TCPA1BS
Installation instructions
General Information
The TCPA1BS is a wireless keyfob that may be worn around the neck, on a wrist band or as an apparel clip that
may also be mounted to a desk. Pressing the keyfob button for at least 1 second and releasing it, sends a
signal to the panel.
Registration and Confi guration
1.
4
*https://international.mytotalconnectcomfort.com
>1.5m
2. To start registration, press the keyfob button for 5 seconds.
Battery Replacement (see fi gure on fi rst page)
The TCPA1BS is powered by a long-life Lithium battery that may be replaced when a low battery is eventually
indicated by the control unit.
1. Remove 4 screws and lift off cover.
2. Using a small fl at-blade screwdriver remove old battery.
3. Insert new battery by placing new battery under the gold tab and then pressing down. Ensure the positive (+)
side of battery is face up after installation.
4. Align cover and attach with 4 screws.
NOTE: When replacing the battery, wait a minimum of 10 seconds prior to installing the new battery.
NOTE: Although water-resistant, please do not immerse in water at a depth below 10cm for more than 1
hour.
Specifi cations:
Unit
LED
Battery
Operating Temperature
CAUTION: risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries
according to battery manufacturer instructions and applicable regulations.
https://international.mytotalconnectcomfort.com
WEB
PORTAL*
Dimensions: 9 mm diameter
lights when unit transmits
3-Volt CR2032 Lithium
-10°C to +55°
English
getconnected.honeywell.com