Assembling The Snowthrower - Snapper 520E Operator's Manual

B
Figure 1. Assembly of Discharge Chute
A. Discharge Chute
B. Carriage Bolts
C. Washers
A
B
Figure 2. Handles
A. Handle B. Wing Knobs C. Clean-out Tool
A
C
D
E
D. Nuts
E. Rotating Ring
C
the Snowthrower
TOOLS REQUIRED
• Socket or Wrench Set
• Pair of Pliers
ASSEMBLY PROCEDURE
If your unit was not previously assembled, see Figures 1
and 2, and follow the steps below to assemble the unit:
1. Install the discharge chute on to the rotating ring
located on the auger housing. Secure with the three
5/16 inch carriage bolts, flat washers and nylock nuts
found in the parts bag (the bolt heads go to inside of
of the rotating ring, with washers and nuts on the out-
side). Note, install the rear bolt first for easier align-
ment.
2. Tighten bolts securely with a wrench.
3. Lift up folding handle to align it with lower handle and
tighten the wing knobs securely as shown in Figure 3.
4. Insert clean-out tool into holders on left handle.
Figure 3. Lift Handles and Lock Wing Knobs
7
Assembling