Yaesu FTM-350R Technical Supplement page 7

VCO VCV Adjustment
Connect the DC voltmeter to TP1302 (MAIN) and
TP1301 (SUB). Referring to the table below, tune the
transceiver to each frequency listed. Confirm that the
correct voltage is present, or adjust the listed setting
for the required voltage.
MAIN
Tune to: TX/RX
440.05 MHz RX
440.00 MHz TX
146.05 MHz RX
146.00 MHz TX
SUB
Tune to: TX/RX
440.05 MHz RX
395.05 MHz RX
146.05 MHz RX
190.05 MHz RX
TP1302
FTM-350AR/E Technical Supplement
for
2.6 ± 0.25 V
1.9 ± 0.25 V
1.7 ± 0.25 V
1.5 ± 0.25 V
for
2.6 ± 0.30 V
1.9 ± 0.25 V
1.4 ± 0.25 V
1.4 ± 0.25 V
TP1301
DC Voltmeter
1. Set the power supply voltage to 13.8 V.
2. Press the [ ADJ ] key to set the alignment Menu
Item to "BAT UP BAT UP". BAT UP BAT UP BAT UP
3. Press and hold in the [ FWD ] key for one second,
to save the new setting.
[ FWD ] key
[ BCK ] key
[ ADJ ] key
TX Power Adjustment
1. Press the [ ADJ ] key to set the alignment Menu
PWR xxx PWR xxx
Item to "PWR xxx PWR xxx PWR xxx".
2. Set the transceiver frequency to 440.000 MHz.
3. Press the [ POW ] key to select "LOW".
4. Press the PTT switch to activate the transmitter,
adjust the left DIAL knob so that the RF Power
Meter reading is 5 W (± 0.5 W).
5. Press the [ POW ] key to select "MID".
6. Press the PTT switch to activate the transmitter,
adjust the left DIAL knob so that the RF Power
Meter reading is 20 W (± 0.5 W).
7. Press the [ POW ] key to select "HIGH".
8. Press the PTT switch to activate the transmitter,
adjust the left DIAL knob so that the RF Power
Meter reading is 50 W (± 0.5 W).
9. Set the transceiver frequency to 146.000 MHz.
10.Press the [ POW ] key to select "LOW".
11.Press the PTT switch to activate the transmitter,
adjust the left DIAL knob so that the RF Power
Meter reading is 5 W (± 0.5 W).
12.Press the [ POW ] key to select "MID".
13.Press the PTT switch to activate the transmitter,
adjust the left DIAL knob so that the RF Power
Meter reading is 20 W (± 0.5 W).
14.Press the [ POW ] key to select "HIGH".
15.Press the PTT switch to activate the transmitter,
adjust the left DIAL knob so that the RF Power
Meter reading is 50 W (± 0.5 W).
The following steps is USA Version only.
16.Set the transceiver frequency to 223.550 MHz.
17.Press the PTT switch to activate the transmitter,
adjust the left DIAL knob so that the RF Power
Meter reading is 1 W (± 0.1 W).
Alignment
11