Microtek ArtixScanDI 6240S User Manual page 46

3. To remove the Separation Roller, hold
4. To install a new Separation Roller onto
5. Close the cover of the Separation
NOTE:
•
•
46 ArtixScan DI 6240S/6250S/6260S & ArtixScan TS 630S User's Manual
the roller and then take it out from the
assembly unit.
the assembly unit, gently hold both
sides of the roller and insert two
flanges on the roller into the notches
of the assembly unit.
Please take note that two flanges on
the roller are designed in different
sizes. The left flange is wider than the
right one. Make sure that you have
put them at the correct side before
inserting them into the slots of the
assembly unit.
Roller Assembly back. Then, push the
scanner cover back until you hear a
"click".
The recommended replacement point for the Separation Roller is
approximately 150,000 scans through the feeder.
Please contact your local resellers for purchasing new Separation Roller.
notch
Flange