Mad Enable - H3C PSR150-A Command Reference Manual

View
VLAN interface view
Default Level
3: Manage level
Parameters
None
Description
Use the mad bfd enable command to enable BFD MAD detection.
Use the undo mad bfd enable command to disable BFD MAD detection.
By default, BFD MAD detection is disabled.
Note the following:
BFD MAD detection links are dedicated. You are not allowed to configure other services on BFD
MAD detection link.
A VLAN interface enabled with BFD MAC detection and the interfaces of this VLAN do not
support any Layer 2 and Layer 3 protocol applications, including ARP and LACP.
You cannot enable BFD MAD detection on VLAN-interface 1.
Examples
# Enable BFD MAD detection on VLAN-interface 3.
<Sysname> system-view
[Sysname] interface vlan-interface 3
[Sysname-Vlan-interface3] mad bfd enable

mad enable

Syntax
mad enable
undo mad enable
View
Aggregation interface view
Default Level
3: Manage level
Parameters
None
Description
Use the mad enable command to enable LACP MAD detection.
Use the undo mad enable command to disable LACP MAD detection.
1-20