Table of Contents
Advertisement
For this command, the latter configuration can only overwrite the former one. Assume that the
current load sharing mode uses the destination MAC address as the hash key. To change it to
the combination of source and destination MAC addresses, you cannot only execute the irf-port
load-sharing mode source-mac command, and you must re-configure the load sharing mode
by executing the irf-port load-sharing mode destination-mac source-mac command.
At present, when configuring IRF port load sharing mode in system view, you can specify: any of
the source IP address, destination IP address, source MAC address or destination MAC address
separately as the hash key; the combination of the source and the destination IP addresses as
the hash key; the combination of the source and the destination MAC addresses as the hash
key.
Examples
# Configure the load sharing mode for IRF port 1/1, using the destination MAC address as the hash
key.
<Sysname> system-view
[Sysname] irf-port 1/1
[Sysname-irf-port 1/1] irf-port load-sharing mode destination-mac
irf-port-configuration active
Syntax
irf-port-configuration active
View
System view
Default Level
3: Manage level
Parameters
None
Description
Use the irf-port-configuration active command to activate configurations on all IRF ports on the
device.
When you physically connect members of an IRF virtual device and bind physical IRF port(s) to an
IRF port whose link state is DIS or DOWN, which you can display with the display irf topology
command, execution of this command is required to establish the IRF virtual device.
Note that activating IRF port configurations may cause merge of IRF virtual devices and automatic
device reboot. Therefore, to avoid configuration loss you are recommended to set the member ID for
the device in the following way:
1)
Plan the network and member IDs in advance. Determine the number of IRF ports to be created,
and which physical IRF ports is used for IRF virtual device establishment.
2)
Change member IDs. (Member ID change takes effective after device reboot, so change
member IDs before executing the irf-port-configuration active command.)
1-18
Advertisement
Table of Contents
