Table of Contents
Advertisement
<Sysname> display mad verbose
Current MAD status: Detect
Excluded ports(configurable):
GigabitEthernet2/0/2
GigabitEthernet2/0/3
Excluded ports(can not be configured):
Ten-GigabitEthernet2/0/25
Ten-GigabitEthernet3/0/26
MAD enabled aggregation port:
Bridge-Aggregation2
MAD BFD enabled interface:
Vlan-interface2
mad ip address 10.0.0.2 255.255.0.0 member 2
mad ip address 10.0.0.3 255.255.0.0 member 3
Table 1-5 display mad command output description
Current MAD status
Excluded ports(configurable)
Excluded ports(can not be configured)
MAD enabled aggregation port
MAD BFD enabled interface
Vlan-interface2
mad ip address 192.168.2.2
255.255.0.0 member 2
mad ip address 192.168.2.3
255.255.0.0 member 3
display switchover state
Syntax
display switchover state [ member-id ]
View
Any view
Field
Current state of the MAD detection, including:
Detect: Detect state, that is, the IRF virtual device is in a
normal state.
Recovery: When multi-active collision occurs, the loser side
enters the recovery state, and all unreserved ports are
automatically disabled.
Detect to Recovery: The intermediate state between detect
and recovery.
Recovery to Detect: The intermediate state between
recovery and detect.
User-configured reserved ports
System reserved ports, which do not need to be configured and
are automatically reserved.
The aggregation port with LACP MAD detection enabled.
The port with BFD MAD detection enabled.
Information of MAD IP addresses in the IRF virtual device,
including the VLAN interfaces on which MAD IP addresses
have been configured, and the MAD IP addresses on all
member devices.
1-7
Description
Advertisement
Table of Contents
