Snapper Mount Mower Set-Up Instructions & Pre-Operation Checklist page 4

Snapper has completed initial adjustments and performed operational tests prior to shipping the machine. Due to the
possible effects of shipping, handling and storage, Snapper intends for all of the following items to be verified and
necessary final adjustments made at time of setup. It remains good practice and is strongly recommended that all the items
also be checked prior to placing the machine into service. It is very important that setup is verified and all operational tests
completed and results are acceptable. After completing this form, sign and retain for future reference.
CUTTING BLADE & MOWER
___ BLADE RETAINING hardware checked for proper tightness (70-80 ft-lbs recommended).
___ MOWER CUTTING HEIGHT settings checked and adjusted as needed (with tires properly inflated).
___ MOWER SIDE TO SIDE level checked and adjusted as needed (with tires properly inflated).
___ MOWER FRONT TO REAR setting checked and adjusted as needed (with tires properly inflated).
PRE-START CHECKS & SERVICES
___ ROLL BAR PROTECTIVE STRUCTURE installed, and hardware tightened to 60-70 ft-lbs (side bar hardware only;
roll bar hardware should allow roll bar to be folded and raised easily).
___ TIRES checked and inflated to correct pressures.
___ ENGINE OIL level checked. See Engine Owners Manual.
___ FUEL added to tank and system checked for leaks.
___ BATTERY charged (if needed) and properly connected, with red boot over positive terminal.
___ HYDRAULIC FLUID level checked.
OPERATIONAL TESTS
___ CHECK SEAT SWITCH for proper function.
___ INTERLOCK SYSTEMS checked to insure proper functioning.
___ SEAT BELTS checked for proper operation.
___ ENGINE STARTED and throttle control settings checked.
___ ALL OPERATIONS as listed on console checked.
___ IGNITION SWITCH checked to insure engine stops when turned to OFF position.
___ PARKING BRAKE tested to insure proper operation.
___ BLADE ENGAGEMENT SWITCH tested for engagement and disengagement of blade.
___ BLADE BRAKE function verified. Blade rotation stops in 7 seconds or less.
___ MACHINE TRACKING tested and adjusted as required.
DEMONSTRATION & INSTRUCTION
___ DEMONSTRATED proper operation of mower to purchaser.
___ INSTRUCTED purchaser to read and follow instructions in Operator's Manual.
___ PERSONALLY HANDED Operator's Manual to purchaser.
___ ASSISTED purchaser in completing Product Registration cards.
DEALER'S RECORDS
Sale Date
Dealer's Name
Address _____________________________ City
Will Mower be used Commercially? Yes ___________________ No
Purchaser's Name
Address __________________________________ City
IMPORTANT: This form is to be retained by the dealer for future reference regarding Warranty, proof of purchase,
traceability for product recall or service, etc. Complete the Product Registration Card and Mail to Customer Service
Department at SNAPPER, PO BOX 1379, McDonough, Georgia, 30253.
COPYRIGHT © 2005
SNAPPER – A DIVISION OF SIMPLICITY MFG., INC.
ALL RIGHTS RESERVED
PRE-OPERATION CHECKLIST
Model Serial No.
Signature
Signature
INSTRUCTION No. 7100083 (I.R. 8/8/2005)
4
State Zip
State Zip