Chapter 2 Configuration; Overview; Safety Messages; Install The Rosemount ™ 628 Gas Sensor Module - Emerson Rosemount 928 Reference Manual

Reference Manual
00809-0100-4928
2 Configuration
2.1

Overview

This section cotains information on configuring the Rosemount
Monitor, including the Rosemount 628 Gas Sensor Module, using Field Communicator or
AMS Wireless Configurator. It also includes Rosemount 628 Gas Sensor Module calibration
information.
2.2

Safety messages

Instructions and procedures in this section may require special precautions to ensure the
safety of the personnel performing them.
WARNING
Failure to follow these installation guidelines could result in death or serious injury.
• Ensure that only qualified persons perform the installation.
WARNING
Explosions could result in death or serious injury.
• Before connecting a handheld communication device in an explosive atomsphere,
make sure that the instruments are installed in accordance with Intrinsically Safe or
non-incendive field wiring practices.
• Verify that the operating atmosphere of the transmitter is consistent with the
appropriate hazardous locations certifications.
• Electrical shock could cause death or serious injury.
• Use extreme caution when making contact with the leads and terminals.
• The power module may be replaced in a hazardous area. The power module has a
surface resistivity greater than one Gigaohm and must be properly installed in the
wireless device enclosure. Take care during transportation to and from the point of
installation to prevent electrostatic charge buildup.
• The surface resistivity of the antenna is greater than one Gigaohm. To avoid
electrostatic charge buildup, do not rub or clean the antenna with solvents or a dry
cloth.
• Substitution of components may impair intrinsic safety.
2.3 Install the Rosemount
The Rosemount 928 Wireless Gas Monitor is compatible with the Rosemount 628 Series
Sensor Modules. These sensors are contained within a sensor module that fits integrally
into the Rosemount 928 Wireless Gas Monitor Transmitter housing without using tools.
Make electrical connections when the sensor module is fully seated in the Rosemount 928
Transmitter sensor module housing.
™
928 Wireless Gas
™
628 Gas Sensor Module
Configuration
August 2018
11