Blade Belt Removal & Replacement; 33" Deck Drive Belt - Snapper LT180H33 IBV Safety Instructions & Operator's Manual

Section 4 - ADJUSTMENT & REPAIR
WARNING
DO NOT attempt any adjustments, maintenance or
service with the engine or blade running. STOP
blade. STOP engine. Set brake. Remove key. Remove
spark plug wire from spark plug and secure wire
away from spark plug. Engine and components can
be extremely hot. Avoid burns by allowing engine and
components sufficient time to cool.
4.4.8. BLADE BELT REMOVAL & REPLACEMENT

33" Deck Drive Belt

1. Place tractor on a firm level surface.
2. Turn engine "OFF". Remove key.
3. Remove mower deck.
4. Remove deck belt idler pulley and spindle pulley
cover. See Figure 4.37.
REMOVE
SPINDLE
PULLEY
COVER
FIGURE 4.37
5. Remove old belt.
6. Replace with new belt in reverse order.
7. Adjust idler pulley belt guide if necessary to obtain
1/16" clearance between belt and belt guide. See
Figure 4.38.
SPINDLE PULLEY
IDLER PULLEY
FIGURE 4.38
REMOVE
IDLER
1/16"
CLEARANCE
30
38" Deck Drive Belt
1. Place tractor on a firm level surface.
2. Turn engine "OFF". Remove key.
3. Remove mower deck.
4. Remove spindle belt guard and tension idler. See
Figure 4.39.
REMOVE IDLER
FIGURE 4.39
5. Remove old belt.
6. Replace with new belt in reverse order.
7. Adjust idler pulley belt guide if necessary to obtain
1/16" clearance between belt and belt guide. See
Figure 4.40.
1/16"
CLEARANCE
(TYPICAL)
SPINDLE
PULLEY
FIGURE 4.40
REMOVE BELT
GUARD
TENSION
IDLER
SPINDLE
PULLEY