Weslo CardioStride 2.0 User Manual page 7

Attach theHood(28)tothefrontof theFrame (29)with
twoM5x 10mm Screws (10).
28
10
.
See drawing 4a. Hold the front of the Frame (29)
between the Left Upright (35) and the Right Upright
(36). Align the holes near the front of the Frame with
one of the two sets of adjustment holes in the Uprights.
Insert the two Adjustment Pins (4) into the holes in the
Uprights and the Frame. Make sure that the
Adjustment Pins are fully inserted at the same
height.
Next, look under the Frame (29) near the Left Upright
(35). See drawing 4b. Locate the Reed Switch Clip (11)
attached to the underside of the Frame. Insert the Reed
Switch (6) into the Reed Switch Clip as shown. Next,
locate the Magnet (12) on the left Flywheel (9). Turn the
Flywheel until the Magnet is aligned with the Reed
Switch. Move the Reed Switch so that there is a 1/8"
(3 ram) gap between the Reed Switch and the
Magnet. Then, tighten the M5 x 12mm Screw (44).
4a
4
44
1/8 in.
View from below
.
Hold the Handrail (5) near the Left and Right Uprights
(35, 36). Connect the Handrail Wire (2) to the Reed
Switch Wire (6). Insert the Wires down into the Left
Upright.
Attach the Handrail (5) to the Uprights (35, 36) with four
M8 x 15mm Screws (33) and four M8 Washers (34). Be
careful not to pinch the Wires (2, 6). Do not fully
tighten the Screws yet.
Place the treadmill in the storage position (see page
11). Center the Frame (not shown) between the
Uprights (35, 36).
See step 1. Tighten the four M8 Nylon Nuts (13).
Then, tighten the M8 × 15ram Screws (33). Lower the
Frame (see page 11).
I
34
7