Snapper 7800979-00 Operator's Manual page 14

13
Installing the Grass Bag
(Optional Accessory on Some Models)
WARNING
Amputation Hazard
• DO NOT attempt any maintenance, adjustments or service
with engine and blade running.
• STOP engine and blade.
• Disconnect spark plug wire and secure away from spark
plug.
Burn Hazard
• Engine and components are HOT.
• Avoid serious burns, allow sufficient time for all
components to cool.
1. Install the grass bag adapter. See Installing the Grass
Bag Adapter .
2. Install the grass bag by sliding the connector (A, Figure 14)
over the adapter flange.
3. Attach the grass bag hooks (B) over the middle handle cross
bar.
14
14
WARNING
Unsafe Operation Hazard
Grass Catcher bags are made of woven fabric, and are subject
to deterioration and wear during normal usage. Check
condition of bag before each use. Immediately replace worn
or damaged catcher bags with only genuine replacement
bags. The grass catcher is optional equipment on some
models.
Charging the Battery
(Optional Accessory on Some Models)
The battery provided with your mower is sealed and
maintenance-free. It requires no special care other than keeping
it properly charged. Use only the charger provided with your
mower when charging the battery.
Charge the battery after each use, and if the battery has been
stored for longer than 30 days. The time required to charge the
battery varies, but typically 16 to 24 hours will be sufficient to
bring the battery to a fully charged condition.
1. Remove the dust cap from the charger jack (A, Figure 15).
2. Plug the battery charger (B) into the charger jack.
3. Plug the charger into a 120-volt wall outlet.
4. Charge the battery for a period of 16 to 24 hours. (Longer
periods will not damage the battery.)
5. Unplug the charger from the wall outlet.
6. Unplug the charger from the charger jack.
7. Replace the dust cap onto the charger jack.
www.snapper.com