Section 2 - Operating Instructions; Pre-Start Checklist; Starting & Stopping Engine & Blades - Snapper ELP21703BV Safety Instructions & Operator's Manual

Section 2 - OPERATING INSTRUCTIONS

2.1 PRE-START CHECK LIST
Make the following checks and perform the service
required before each start-up.
2.1.1. Check guards, deflectors, grass bag, adapter
and covers to make sure all are in place and securely
tightened.
WARNING
DO NOT start or operate this machine without
installing the recycling plug or the entire grass
catcher.
2.1.2. Check blade control and wheel drive control
to insure they work freely. See Figure 2.1.
WHEEL
DRIVE
CONTROL
FIGURE 2.1
2.1.3. Check cutting height. Adjust to desired height.
2.1.4. Check engine oil and add oil as needed to bring
level up to the full mark. Refer to Engine Owner's
Manual for oil specifications. See Figure 2.2.
FUEL CAP
FIGURE 2.2
2.1.5. Add fuel to tank after pushing the mower
outside where fumes can safely dissipate. Make sure
cap is tightened after refueling. Refer to Engine
Owners Manual for specifications.
2.1.6. Clean exterior surfaces of cutting deck and
engine of any accumulation of spilled fuel, dirt, grass,
oil, etc. Keep engine air intake screen and cooling
fins clear at all times.
2.2 STARTING & OPERATION
2.2.1. ENGINE & BLADE
(Primer Models) (Recoil Start)
1. Move engine speed control to the "Fast" (Rabbit)
position. See Figure 2.3.
IMPORTANT: Stop the engine (and blade) by releasing
the blade control.
BLADE
CONTROL
ENGINE
SPEED
CONTROL
SLOW
FAST
OIL
FILL/CHECK
2. Push primer button three times to start a cold
engine. NOTE: Do not use primer button to start
warm engine.
3. Pull blade control against handle.
4. Pull rope start handle to crank engine.
5. After engine starts, allow a brief warm-up until
engine runs smooth.
7
TO START
TO STOP
PRIMER
BUTTON
FIGURE 2.3
BLADE
CONTROL