Snapper ELP21703BV Safety Instructions & Operator's Manual page 18

GROUND
SPEED
DECAL
P/N 7-5475
(7) GROUND SPEED: Shows direction of movement
and the ability to select one of three ground speeds by
moving the lever. The number 3 (Rabbit) indicates the
top speed, number 2 indicates the medium speed and
the number 1 (Turtle) indicates the slowest speed.
(8) HEIGHT CONTROL
direction of movement of HEIGHT ADJUST HANDLE to
select a change in height if cut from highest cutting
height (clockwise) to the lowest height (counter-
clockwise). Note that there is a total of eleven heights
of cut.
(9) NOISE CONTROL: This unit is certified to be within
the 100 dBA sound power limit at the specified Engine
RPM.
DECAL IDENTIFICATION
FAST SPEED
(RABBIT)
rd
3 TOP SPEED
nd
2 MEDIUM SPEED
st
1 SLOW SPEED
SLOW SPEED
(TURTLE)
HEIGHT
CONTROL
DECAL
P/N 2-8454
INSTRUCTION: Shows
EUROPEAN NOISE
CONTROL DECAL
74135
(10) EUROPEAN PERFORMANCE: Maximum level of
vibration measured at the operators hand is 23.4
m/sec2.
(11) OPERATOR PRESENCE CONTROL: Pull control
against handle to start engine and blade. Release
control to stop engine and blade.
(12) GROUND DRIVE: Located on the plastic grip of
the wheel drive control lever. Pull lever against handle
to engage drive. Release lever to disengage drive.
18
EUROPEAN
COMMUNITY
DECAL
29776
OPERATOR PRESENCE
CONTROL DECAL
P/N 2-9782