Electrolux TW SL EP User Manual page 45

• To keep vibration and noise at the mini-
mum, when the tumble dryer operates, it
must be put on a stable and flat surface.
• When the appliance is put in its perma-
nent position, check if is fully level with
the aid of a spirit level. If it is not, adjust
the feet until it is.
• Do not remove the feet. Do not decrease
the floor clearance through thick carpets,
bar of wood or equivalent. This can in-
crease the heat which can cause interfer-
ence with the operation of the appliance.
Important!
• The temperature of the hot air which oc-
curs in the tumble dryer can increase to
60 °C. The appliance must not be instal-
led on the floor which is not resistant to
high temperatures.
• When the tumble dryer operates, the
room temperature must not be lower
than +5 °C and higher than +35 °C. This
can cause unwanted effect on the per-
formance of the appliance.
• If it is necessary to move the appliance, it
must be moved vertically.
• The appliance must not be installed be-
hind a lockable door, a sliding door, a
door with a hinge on the opposite side to
that of the appliance in such a way that a
full opening of the tumble dryer is restric-
ted.
UNPACKING
Caution!
Before use all parts of the transport pack-
aging must be removed.
To remove the polystyrene blockages:
1. Open the load door.
2. Pull plastic hose with the polystyrene
blockages out from the drum.
It is possible to adjust the height of the tum-
ble dryer. To do that adjust the feet (see
picture).
15mm
INSTALLATION UNDER A COUNTER
The appliance can be installed as free-
standing or below the kitchen counter with
correct space (see picture).
600 mm
600 mm
> 850 mm
THE LOAD DOOR REVERSAL
The load door can be installed by the user
in the opposite side. It can help to easily put
electrolux 45