Hints And Tips - Electrolux TW SL EP User Manual

Table of Contents

Advertisement

Available languages

Available languages

36 electrolux
(Signal) function is on, an acoustic signal
sounds intermittently for one minute.
To remove the laundry:
1. Push the Auto/Off button for 2 seconds
to deactivate the appliance.
2. Open the appliance door.
3. Remove the laundry.

HINTS AND TIPS

ECOLOGICAL HINTS
• Do not use fabric softener to wash and
then dry. In the tumble dryer laundry be-
comes soft automatically.
• Use the condensate as distilled water,
e.g. for steam ironing. If it is necessary
clean the condensate before (e.g. with a
coffee filter) to remove possible small
pieces of fluff.
• Always keep the airflow slots on the bot-
tom of the appliance clear.
• Use the load volumes which are specified
in the programmes chapter.
• Make sure that is good airflow in the ap-
pliance installation position.
• Clean the primary filter after each drying
cycle.
• Clean the heat exchanger filters when the
applicable indicator comes into the view
on the control panel.
• Spin good the laundry before drying.
AVERAGE LAUNDRY WEIGHTS
bathrobe
quilt cover
man's work shirt
man's pyjamas
sheet
tablecloth
man's shirt
night dress
pillow case
towelling towel
blouse
ladies' briefs
men's underpants
napkin
tea cloth
4. Close the appliance door.
Important! After each drying cycle:
• clean the filter
• drain the water container
(See chapter CARE AND CLEANING.)
WATER HARDNESS AND
CONDUCTIVITY
Water hardness can be different for differ-
ent locations. Water hardness has an effect
on the water conductivity and the operation
of the conductivity sensor in the appliance.
If you know the value of the water conduc-
tivity you can adjust the sensor to dry with
the better results.
To change the sensor conductivity:
1. Turn the programme dial to available
programme.
2. Push at the same time 2 buttons (see
the illustration). Hold down until one of
the symbols come into view on the dis-
play:
1200 g
700 g
600 g
cm
500 g
500 g
300-600 μS/cm
250 g
cm
200 g
3. Push the button again and again until
200 g
you set necessary level (see the illustra-
tion).
200 g
200 g
100 g
100 g
100 g
100 g
100 g
low conductivity <300 μS/
moderate conductivity
high conductivity >600 μS/

Advertisement

Chapters

Table of Contents
loading

Table of Contents