Driven Disc Replacement; Driven Disc Adjustment - Snapper 2167519B, P2167519B, P217019BV, P217019BVE, P216019KWV Operator's Manual

Section 4 - REPAIR & ADJUSTMENTS
WARNING
DO NOT attempt any maintenance, adjustments or
service with engine and blade running. STOP engine
and blade. Disconnect spark plug wire and secure
away from spark plug. Engine and components are
HOT. Avoid serious burns, allow sufficient time for
all components to cool.

4.3.3. DRIVEN DISC ADJUSTMENT

(Continued From Previous Page)
2. Remove driven disc spring from driven disc
assembly. Also remove pin and washer from transfer
rod, and remove end of transfer rod from hole in
driven disc assembly. See Figure 4.9.
REMOVE
DRIVEN DISC
SPRING
REMOVE END
REMOVE
OF TRANSFER
PIN AND
ROD FROM
WASHER
DRIVEN DISC
FROM ROD
ASSY
3. Slide driven disc assembly over to 1/8" from
outside edge of drive disc. See Figure 4.10.
4. Loosen jam nut securing transfer rod to ball joint
on pivot bracket. See Figure 4.11.
5. Turn rod in or out of ball joint until end of rod aligns
with hole in driven disc assembly from which rod was
removed. NOTE: Do not move pivot bracket.
6. Reinstall rod as removed in step 2. Move ground
speed control to 'slow' position, then back to 'fast'
position. Recheck the 1/8" measurement described
previously. Readjust as needed. Tighten nut when
finished.
7. Reinstall driven disc spring to driven disc
assembly.
DRIVEN DISC
ASSEMBLY
FIGURE 4.9
SLIDE DRIVEN
DISC ASSEMBLY
TOWARD OUTSIDE
EDGE
DRIVE
DISC
PIVOT
BRACKET
4.3.4. Replacing Rubber Driven Disc
If the rubber is badly chunked or worn it must be
replaced. Install new Driven Disc as follows:
1. Remove pin and washer from transfer rod, and
remove end of transfer rod from hole in driven disc
assembly. See Figure 4.9.
17
1/8" MEASUREMENT TO
OUTSIDE EDGE OF DRIVE
DISC
FIGURE 4.10
BALL JOINT
LOOSEN NUT
TURN ROD IN
OR OUT UNTIL
END ALIGNS
WITH HOLE
FIGURE 4.11
(Continued On Next Page)
DRIVE
DISC
OUTSIDE
EDGE