Recycling Operation; Section 2 - Operating Instructions; Installation Of Grass Catcher - Snapper 216015, 216515BV Operator's Manual

Section 2 - OPERATING INSTRUCTIONS

WARNING
DO NOT attempt any maintenance, adjustments or
service with engine and blade running. STOP engine
and blade. Disconnect spark plug wire and secure
away from spark plug. Engine and components are
HOT. Avoid serious burns, allow sufficient time for all
components to cool.

2.6 RECYCLING OPERATION

(Optional Accessory)
NOTE: For best recycling results, cut up to a maximum of
1/3 of grass blade length and recycle ONLY when grass is
dry.
1. Set all wheels in the highest cutting position
(Notch 6).
2. Move engine speed control to "FAST" (Rabbit)
position.
3. Move ground speed control to slowest speed
setting.
4. Proceed mowing slowly. If grass is very dense,
lower each rear wheel latch one notch lower than
the front wheel latches to improve recycling
performance.
WARNING
DO NOT operate without entire Grass Catcher or
guard in place. Grass Catcher components are
subject to deterioration during normal use. Inspect
frequently and replace worn or damaged components
immediately.

2.7 INSTALLATION of GRASS CATCHER

Install grass catcher by sliding connector over flange
of adapter. See Figure 2.7. Attach grass bag hooks
over middle handle cross bar. See Figure 2.8.
POSITION BAG
BETWEEN HANDLES
BAG
ADAPTER
FIGURE 2.7
SLIDE
CONNECTOR
DOWN OVER BAG
CONNECTOR
ADAPTER FLANGE
ATTACH BAG HOOKS
OVER MIDDLE HANDLE
CROSS BAR
8
MIDDLE
HANDLE
CROSS BAR
FIGURE 2.8