Advertisement
2.
Lift the camera body to separate the
junction box and the adapter plate.
3.
Separate the junction box (1) and the
adapter plate (2).
4.
Unscrew the bubble assembly (3).
5.
Screw the cup base onto the wall mount
and tighten with the locking screw, as
shown below (A). Attach the camera
adapter plate to the cup base (B) using
screw A, routing the camera cables
through the adapter plate.
6.
Route the camera cables through the
inside junction box, align the "FRONT"
marks located on the inside of the
junction box with the marking on the
adapter plate, and then secure the
junction box to the adapter plate by
tighening the three torx screws.
4 / 5
7.
Attach the safety lanyard and connect
the camera cables to the base of the
dome camera. Follow the instructions in
the dome installation guide to ensure the
IP67 rating.
8.
Install the camera body to the junction
box using the three torx screws located
in the dome housing, near the edge of
the housing. Reinstall the bubble
assembly.
Legal and regulatory
information
Copyright
© 2018 United Technologies Corporation.
All rights reserved.
Interlogix is part of UTC Climate, Controls
& Security, a unit of United Technologies
Corporation.
Trademarks and
The trade names used in this document
patents
may be trademarks or registered
trademarks of the manufacturers or
vendors of the respective products.
Manufacturer
Interlogix.
2955 Red Hill Avenue, Costa Mesa, CA
92626 5923, USA
Authorized EU manufacturing
representative:
UTC Fire & Security B.V.
Kelvinstraat 7, 6003 DH Weert, The
Netherlands
Certification
P/N 1073469-EN • REV A • ISS 24AUG18
Advertisement
