Advertisement
3.
Lift the camera body to separate the
junction box and the adapter plate.
4.
Separate the junction box (1) and the
adapter plate (2).
5.
Unscrew the bubble assembly (3).
6.
Screw the cup base onto the swan neck
mount and tighten with the locking screw.
Route the camera cables through the
adapter plate.
7.
Place the adapter plate on the cup base.
Using screw A, secure the adapter plate
to the pendant mount.
8.
Route the camera cables through the
inside junction box, align the "FRONT"
marks located on the inside of the
junction box with the marking on the
adapter plate, and then secure the
junction box to the adapter plate by
tightening the three torx screws.
P/N 1073469-EN • REV A • ISS 24AUG18
9.
Attach the safety lanyard and connect
the camera cables to the base of the
dome camera. Follow the instructions in
the dome installation guide to ensure the
IP67 rating.
10. Install the camera body to the junction
box using the three torx screws located
in the dome housing, near the edge of
the housing. Reinstall the bubble
assembly.
To mount a dome camera to a TVD-
CBW wall mount with a TVD-CB7 cup
base:
1.
Route the camera cables through the
wall mount. Attach the wall mount to the
wall using the expansion anchors that
are provided with the TVD-CBW.
3 / 5
Advertisement
