Yamaha JT1 Series Assembly Manual page 21

B. Installing Taillights (JTl-L, 1971½)
1. Follow 2, 3, 6, and 7, page
10, JT-1 Section, where
they apply to the following:
2.
Place the rubber damper against the tai
I
light bracket as shown in the
drawing, right. Place a flat washer over the shafts of the securing
bolts (2) and insert them into their mounting holes on the bracket so
that their threaded portions protrude past the damper.
3
Place the bracket and damper assembly on the rear fender with the
threaded portions of the mounting bolts passing through. Install the
large, flat washer, lock washer, and securing nut, in that order. Tight-
en both nuts thoroughly .
C.
Installing Taillights (JT2-L, 1972}
1. Fol low steps 2, 3, 6, and
7, page 10, JT-2 Section,
where they apply, then do
the following:
2. Remove the two fender se-
curing bolts located on the
upper rear frame loop.
3.
Insert the upper bracket stay and reinstall the mounting bolts. Tighten
securely. Install the bracket mounting bolts. Make sure the taillight
~ound strap is situated with good metal-to-metal contact between the
bolt and bracket. Secure both bolts.
4. Install reflectors (2) .
32
D. Ignition Switch Installation (JT2-L, 1972)
1.
Place the ignition switch
on the mounting bracket.
Install the lock washer
over the Phi
II
ips screw .
Insert the screw in the
mounting bracket hole and
secure with the lock nut.
E.
Speedometer Cable Installation (JT2-L, 1971)
1. Install the damper rubber
on the base of the speed-
ometer assembly.
2.
Insert the threaded portion
of the speedometer cable
through the access hole on
the triple clamp upper
bracket and damper rubber.
Tighten securely in its
mounting on the speedom-
eter.
3.
Insert the speedometer mounting pins 1n the holes provided ,n the
cl amp bracket.
4. Install the "D" shaped cup washer (2) and hairpin clips.
5. Route the speedometer coble down along the right-hand fork leg and in-
sert the male end of the cable into the speedometer drive fitting on the
frhont
1
wheel hub. If the cable end refuses to engage, rotate the front
w
ee.
6. With the male end fully inserted and bottomed against its seat, install
the spring type securing clip .
33