Table of Contents
Advertisement
of XXX en, A31nnn-Xnnnn-Xn-n-nnnn (30.05.2006, 20:58)
left page (30)
30
Product data
Product data
Declaration of conformity
BenQ Mobile hereby declares that the
phone described in this user guide is in
compliance with the essential requirements
and other relevant provisions of European
Directive 1999/5/EC (R&TTE). The relevant
declaration of conformity (DoC) has been
signed. Please call the company hotline if
you require a copy of the original or visit:
www.BenQMobile.com/conformity
This device complies with
Part 15 of the FCC Rules.
Operation is subject to the
following two conditions:
1. this device may not cause harmful
interference, and
2. this device must accept any
interference received, including
interference that may cause
undesired operation.
Changes or modifications not
expressly approved by the party
responsible for compliance could void
the user's authority to operate the
equipment.
For body worn operation, this phone has
been tested and meets the FCC RF exposure
guidelines for use with an accessory that
contains no metal and that positions the
handset a minimum of 1.5 cm from the
body. Use of other enhancements may not
ensure compliance with FCC RF exposure
guidelines. If you do not use a body-worn
accessory and are not holding the phone at
the ear, position the handset a minimum of
1.5 cm from your body when the phone is
switched on.
Lost phone
If you lose your phone or SIM card contact
your service provider immediately to
prevent misuse.
FEDERAL COMMUNICATIONS COMMISSION
INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference
by one or more of the following measures:
-Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
Consult the dealer or an experienced radio/ TV technician for help.
CAUTION:
Any changes or modifications not expressly approved by the grantee
of this device could void the user's authority to operate the equipment.
RF exposure warning
This equipment must be installed and operated in accordance with
provided instructions and must not be co-located or operating in conjunction
with any other antenna or transmitter. End-users and installers
must be provide with antenna installation instructions
and transmitter operating conditions for satisfying
RF exposure compliance.
Advertisement
Table of Contents
