Operating Symbols And Their Meanings - Craftsman C950-52850-0 Owner's Manual

13.5 t.p. 27 inch dual stage snowthrower
Table of Contents

Advertisement

Available languages

Available languages

Operating Symbols and their meanings

These symbols are used on your equipment and defined in your operating
manual. It is important that you review and understand the meanings.
Failure to understand the symbols might result in harm to you.
Oil
Fuel
On Off
Primer bulb
Throttle
Choke off
Choke on
Stop
Slow
Fast
Engage
Traction
Auger Collector
Auger Clutch
Drive Clutch
Engage
Disengage
Discharge Chute
LEFT
RIGHT
RULES FOR SAFE OPERATION
Forward
Neutral
Reverse
Ignition On
Ignition Off
Ignition Key
Push to engage
electric start
Electric
Start
Engine
Start
Engine Run
Engine Off
Heated Grips
Chute Deflector
DOWN
UP
Avoid death or serious injury from rotating auger.
Keep hands, feet and clothing away.
Unclogging discharge chute is a hazardous activity.
Stop engine and disconnect spark plug wire when performing maintenance
on equipment.
Never leave the equipment unattended while engine is running. Always
disengage the auger and traction controls, stop engine, and remove keys.
Keep children, pets, and others out of the area during operation. Children
are often attracted to the equipment. Be mindful of all persons present.
Keep all loose clothing far away from front of snow thrower and auger.
Scarves, mittens, dangling drawstrings, loose clothes and pants can
quickly become caught in the rotating device and dismemberment will
occur. Tie up long hair and remove jewelry.
The snow thrower is intended to remove snow only. Do not use for
purposes other than what is intended.
Do not clear snow across the face of slopes. Exercise extreme caution when
changing direction on slopes. Do not attempt to clear steep slopes.
Do not use the snow thrower on surfaces above ground level such as roofs
of residences, garages, porches or other such structures or buildings.
Discharge chute contains rotating impeller to throw snow.
Never clear or unclog discharge chute with your hands, or
while engine is running.
Fingers can quickly become caught and traumatic
amputation or severe laceration can result.
Unclogging the discharge chute is a hazardous activity. Clogged or
blocked augers store energy and can rotate unexpectedly.
Never place hands in or near discharge chute.
With engine OFF, wait for all moving parts to cease movement, then with a
stick, clear the chute. Even with engine off, parts may rotate and
dismemberment can occur.
Clogged snow can hide other obstructions in the chute and cause damage
to the equipment, impeller or auger. Take precautions when restating the
equipment after snow removal.
3
DANGER
DANGER

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents