Assemble Upper/Lower Handles; Check The Cables; How To Set The Length Of The Cables - Craftsman C950-52850-0 Owner's Manual

ASSEMBLE UPPER/LOWER HANDLES

1. Raise the upper handle (A, Figure 4) to the operating
position.
NOTE: Make sure the cables are not caught between
the upper and lower handle.
2. Assemble the upper and lower handle (A, B) as
shown in Figure 4.
3. Make sure all fasteners (C) are secure.
4. Roll the snowthrower off the carton by pulling on the
lower handle.
CAUTION: DO NOT back over cables.

CHECK THE CABLES

1. If control cables have become unattached from
motor mount frame, reconnect traction drive cable
(D, Figure 4) and auger drive cable (E) as shown.
2. For cable adjustments, see "How To Check And Adjust
The Cables" in the ADJUSTMENT/REPAIR section.
HOW TO SET
THE LENGTH OF THE CABLES
The cables were adjusted at the factory and no adjustments
should be necessary. However, after the handles are put in
the operating position, the cables can be too tight or too
loose. If an adjustment is necessary, see "How To Check And
Adjust The Cables" in the ADJUSTMENT/REPAIR section.
ASSEMBLY
A
B
E
11
C
D
Figure 4