The following terms are used throughout the instruction manual LEFT-SIDE LIGHTS RIGHT-SIDE LIGHTS These two lights indicate These two lights indicate the selected power the power the appliance is operating at. Power selector Foot switch Thermostat Dial Electronic Heating Convector BBH200...
Insert the plug into the mains socket and switch on, pressing the ECC button (fig.2/3/4/5) one or more times, to select your operat- ing heating power as follow: Fig.5 Each time you push the ECC button a “bleep” will be heard. Press four times (Off) Electronic Heating Convector BBH200...
Page 4
When set in this way, the heater will maintain a minimum room temperature of approximately 5°C thus preventing freezing with minimum energy consumption. This function is not guaranteed in the event of power failures, even if lasting just a few seconds. Electronic Heating Convector BBH200...
- It is normal for the heater to make "crackling" noises when reheating and cooling. IMPORTANT: Never for any reason cover the appliance during operation as this could lead to dangerous over heating. Electronic Heating Convector BBH200...
Page 6
- A safety device intervenes and turns off the appliance in the event of overheating or because the appliance is positioned in a strong draught of air.To reactivate it, remove the plug from the electrical outlet, allow the appliance to cool (about 5 mins), remove the cause of the overheating/draught and then recon- nect the appliance to the mains and turn it back on.
The blue wire must be connected to the terminal marked with the letter N or coloured black. The brown wire must be connected to the terminal marked with the letter L or coloured red. Electronic Heating Convector BBH200...