Table of Contents
Advertisement
be sure the Table is fixed in place at
the desired miter angle.
3.
Blow any sawdust or debris away
from the Fence. Place the work
material against the Fence.
4.
Make any necessary miter or bevel
adjustments.
5.
Align the marked location of the cut
on the work material with the saw
blade. Be aware that the Saw Blade
will remove material from the cut
equal to the width of the blade. This is
the "kerf". To prevent your work piece
from being cut too short, align the
edge of the blade with your measured
mark, keeping the kerf on the waste
side of the cut.
6.
Hold the work material in place using
the Project Clamp. Ensure that the
work material is level and supported
securely, using saw horses or
supports if necessary.
7.
Grip the Saw Handle and squeeze
the Trigger Switch (4) to start the
Blade turning.
8.
Pressing straight down lightly, cut
through the material. Do not bear
down on the material, use light
downward pressure. If the material
binds the blade, release the Trigger
Switch. Keep your hands away from
the Blade.
9.
When the cut is completed, raise the
blade assembly, wait for the Blade to
stop turning, release the Clamp and
remove the work material from the
saw.
10.
When finished working, unplug the
electrical cord, clean the tool surfaces
SKU 67411
For technical questions, please call 1-800-444-3353.
with a clean cloth and store the tool
indoors away from children.
Page 13
Advertisement
Table of Contents
