QIR.book Page 11 Thursday, April 17, 2008 3:14 PM
■ Attaching
aHolding the tab, pull out the tray until it clicks.
Tray
Tab
bPut UIM with the IC side upward on the tray in the
direction shown in the figure.
UIM
IC
Corner cut
cPush the tray fully until it stops.
■ Removing
aHolding the tab, pull out the tray until it clicks and
carefully remove UIM.
Tab
Attaching/removing battery pack
•
After turning the power OFF, fold the terminal and
hold it with your hand.
■ Attaching
aRemove the back cover by sliding it about 2 mm in
the direction of the arrow while pressing it with your
thumb.
Back Cover
11
UIM slot
Press here with your thumb