Instructions For The Installer; Electrical Connection - Electrolux EOB 3000 Instruction Booklet

Hide thumbs Also See for EOB 3000:
Table of Contents

Advertisement

Available languages

Available languages

Instructions for the Installer

Technical Data
Recess dimensions
Height
in coloumn
undertop
Width
Depth
Oven cavity dimensions
Height
Width
Depth
Volume

Electrical connection

Only qualified personnel should install the appliance (place in cabinet and make electrical connection).
Every operation must be carried out with appliance disconnected from the electricity supply; when this is
not possible the maximum care is required when working on the appliance.
Before proceeding to the connection of the oven make
sure that:
-
the limiting valve and the domestic electrical circuit
are sufficient to support the load of the appliance (see
identification plate);
-
the electrical system is equipped with an earthing
cable in accordance with current norms and legal
provisions;
-
the plug or omnipolar switch used to carry out the
connection is easily accessible once the appliance
is installed.
The appliance is supplied with power cable, the
conductors of which have a minimum section of 3x1.5
mm. Besides this, the cable has a normalised plug
suitable for the electrical load indicated on the
identification plate.
The plug should be connected to a suitable elctrical
socket.
If a direct connection to the supply is desired an omnipolar
switch having a minimum opening of 3mm between the
contacts must be installed between the appliance and
the electricity supply; this switch must be suitable for
the electrical load of the appliance and must conform to
the current norms.
The yellow/green earth wire must not be interrupted by
the switch and it shouldbe 2-3 cm longer than the other
cables.
In every case the supply cable must be positioned insuch
a way that it can, at no time, reach temperaures of more
than 90°C.
After connection test the heating elements by putting
them into operation for abour 3 minutes.
Oven elements
Bottom heating element
Top heating element
580 mm
Full Oven (Top+Bottom)
593 mm
Grill heating element
Fan Oven heating element
560 mm
Oven lamp
550 mm
Convection fan
Cooling fan
Maximum power rating
Voltage tension (50 Hz)
335 mm
395 mm
400 mm
53 l
The manufacturers decline all responsibility for
damage or accidents in cases where norms
have not been observed and respected.
1000 W
800 W
1800 W
1650 W
2000 W
25 W
25 W
25 W
2050 W
230 V
15

Advertisement

Table of Contents
loading

Table of Contents