Table of Contents
Advertisement
11. AUTOMATIC RELEASE SYSTEM REPLACEMENT
11.1. Description
The automatic release system assembly is composed of a HAMMAR release system (A) and a severable axis (B)
fitted with a rubber washer (C).
11.2. Replacement
Refer to drawing next page.
Open the container and remove the beacon
(1)
Unscrew the severable axis (B) while maintaining pressed down the ejection plate (D) of the beacon and its
blocking piece (E).
(2)
Remove the automatic release system assembly.
(3)
On the new HAMMAR release system, tick the new replacement date (actual month / year + 2 years. Example
on drawing next page: release system replaced on Nov 2008, valid until Nov. 2010).
(4)
Press down the ejection plate (D) and maintain it pressed with its blocking piece (E).
(5)
Screw the new automatic release system assembly in the screw of the blocking piece.
Put back the beacon into the container and close the container
Record the release system replacement page
32
(See 6.2.2. Installation of beacon into
(See 6.2.2. Installation of beacon into
37
of this manual.
DOC09028A
container).
container).
Advertisement
Table of Contents
