Liebert S600 User Manual page 55

Alarm
utility transition
Manual power-on
Manual shutdown
Operating
inverter
Battery series set
to 12 (12~20)
Battery series set
to 24 (24~40)
Restore factory
defaults
Output phase No.
set to 1
Output phase No.
set to 3
UPS is out of
service
Turn on
programmable
outlet
Turn off
programmable
outlet
System parallel
settings start
sync
Local settings
sync OK
System settings
sync OK
Load off due to
output short
Output off due to
overload &
bypass abnormal
Vertiv|Liebert® S600 10kVA ~ 20kVA UPS | User Manual
Explanation
Set power-on via LCD panel
Set shutdown via LCD panel
on
The UPS output state is on inverter
The battery cells changed (10kVA)
The battery cells changed (20kVA)
Under UPS stadby state, set 'Restore Factory Defaults' function via the Miantain
page
The output phase is changed from 3-phase to 1-phase
The output phase is changed from 1-phase to 3-phase
The UPS is out of service
The programmable outlet status is changed from Turn Off to Turn On
The programmable outlet status is changed from Turn On to Turn Off
Manually set the 'Sync parallel paremters' command to activate the event
Local parameters are successfully synchronized
All the parameters are successfully synchronized
The inverter short circuit or the bypass short circiut. Please check it
The output is off due to output overload and bypass abnormal. Please check it
55