Setting The Service Mode - Canon imageRUNNER iR2270 Service Manual

Chapter 3
Turn the main power off, and after 10 seconds, turn it on again.
(5) The registered license will be validated when the power supply of the device itself is
turned on once again.
At the first reboot after the license key registration, in some cases, it might take 30 min. or
more in order to initialize the data in HDD. If the data erasing method of HDD of the device
is set to "Overwrite random data 3 times", it might take longer than the cases above. Make
sure not to turn off the power supply when the message, "Remaining data that is not needed
is being erased. Do not turn off the main power.", is displayed.
(6) When the device starts normally, press counter key and then press the device
configuration to check if the security kit is displayed in the space of options. Then, set the
Service mode at user's request.

3.3.3 Setting the Service mode

When this kit is installed, the Service mode needs changing in response to the user's request.
1. Changing the setting of "Complete erasing of HDD"
Change the setting of complete erasing of HDD at user's request.
- Service mode level 2
COPIER>OPTION>USER>HDCR-DSP
Set value
1: Overwrite NULL data one time
2: Overwrite Random data one time
3: Overwrite Random data three times
Default value: 1
Note:
As the value is set higher, the security level becomes higher while the performance level
becomes lower.
2. Switching the key of "Job history display ON/OFF" between display and not
display
Switch the key of "Job history display ON/OFF" between display and not display.
- Service mode level 2
COPIER>OPTION>USER>LGSW-DSP
3-10
0008-2981