Inserting The Battery - Vertu SIGNATURE RM-466V Reference Manual

Inserting the battery

Always switch the phone off and disconnect the
charger before touching the battery.
R e m o v e t h e b a t te r y c o v e r
2
I n s e rt th e b at te r y
1
2
With the back of the Vertu
phone facing you, lift the
top half of the battery
cover release D-ring with
your finger nail.
Hold it between your
thumb and forefinger and
turn anticlockwise until
the back cover pops
open.
Raise the battery cover
slightly (1) and then move
the cover gently towards
the top of the phone (2).
1
Insert the battery at an
angle (1) so that the
battery contacts align with
the contacts in the battery
compartment.
Lower the battery into the
battery compartment (2)
and ensure that the
battery is seated correctly
before replacing the
battery cover.
R e p l a c e t h e b a t t e ry c ov e r
2
3
I n s e r t th e S I M c a rd
Always switch the phone off before inserting or
removing the USIM/SIM card.
Keep SIM cards out of the reach of small children.
The SIM card and its contacts are easily damaged.
Be careful when handling, inserting or removing the SIM card.
2
1
English
4
GETTING STARTED
To replace the battery
cover, carefully insert the
internal clip(1) on the
inside of the battery cover
into the slot below the
battery (2).
1
Lower the battery cover
into position (3) until it
clicks into place. The
cover should close tightly
using only light pressure.
To open the SIM drawer,
insert a finger nail under
the SIM drawer release
lever (1). Fully extend the
lever until the SIM drawer
(2) is half way out of the
phone. Fully remove the
SIM drawer from the
phone.
Place the SIM in the SIM
drawer, aligning the
slanted corners and
ensuring the SIM is
seated properly in the
drawer.