Hot plug components
8.2.2
Installing/removing the dummy unit
Free slots are provided with a dummy module that must be removed before
installing an additional HDD module.
Figure 17: Removing the dummy unit
Ê Press both tabs on the dummy module together until the locking mechanism
disengages and remove the dummy module from the mounting location.
To install a dummy unit, follow the same procedure in reverse order.
V
CAUTION!
Keep the dummy unit for future use. If the HDD module is removed again
and not replaced with a new module, the dummy module must be
reinstalled due to cooling, to comply with applicable EMC regulations
(regulations on electromagnetic compatibility) and to protect against fire.
RX200 S3
Hot-pluggable hard disk drives
Operating Manual
71