Removing/Installing The Dummy Module - Fujitsu PRIMERGY RX300 S3 Operating Manual

Hot-plug Hard Disk Drives
8.2.2

Removing/installing the dummy module

Free slots are provided with a dummy module that must be removed before
installing an additional HDD module.
Removing/installing the 3.5-inch dummy module
Figure 19: Removing the 3.5-inch dummy module
Ê Press both tabs on the dummy module together (see
locking mechanism disengages and remove the dummy module from the
mounting location.
The dummy module is installed in the reverse order.
V
CAUTION!
Keep the dummy module for future use. If the HDD module is removed
again and not replaced with a new module, the dummy module must be
reinstalled due to cooling, to comply with applicable EMC regulations
(regulations on electromagnetic compatibility) and to protect against fire.
78 Operating manual
Hot-plug Components
figure 19) until the
RX300 S3