Installing/Removing The Server In/From The Rack - Fujitsu PRIMERGY RX200 S3 Operating Manual

Hardware Installation
4.2 Installing/Removing the Server in/from the
Rack
V
CAUTION!
Please note the safety instructions in
mation" on page 17
Rack" on page
At least two people are needed to position the server into/out of
the rack.
The rack can tip over when more than one slide-in module is
pulled out.
The server may not occupy the top height unit of the rack (38 HU/42
HU PRIMECENTER Rack and/or DataCenter Rack), as otherwise
boards or fans cannot be replaced even with the plug-in module fully
extended.
Rack requirements
The rack systems of the Fujitsu Siemens Computers (PRIMECENTER Rack
and DataCenter Rack) support fully the installation of the PRIMERGY server
systems. Installation in most current rack systems from other manufacturers
(3rd party racks) is also supported.
To accommodate the ventilation concept and ensure proper ventilation, any
unused areas in the rack must be sealed using dummy covers.
The power is supplied via the multiple socket outlets fitted in the rack.
The main features of the rack systems of the Fujitsu Siemens Computers are:
RX200 S3

Installing/Removing the Server in/from the Rack

and section "Notes on Installing in the
26.
Operating Manual
chapter "Important Infor-
31